Pengo board shipped!

My pengo pcb is back on it’s way to me from Pittsburgh via ground. It should work from what I hear.

I need to double check my power supply. It was fine when I looked at it before, but it is always good to double check. If I felt more proficient I would probably look at a switcher instead.

Supposedly the board didn’t have a chip that was fully seated, or a leg was bent or something. I tried reseating them myself, and didn’t notice a change. I was also really careful about the legs, so I don’t doubt it was bent, I just wish I knew how it got that way.

Here are some similar arcade posts

• Got my Pengo High-Score Saver and Enhancement Pack
• Figuring out OL, OH Dig Dug PCB error
• Pengo PCB problem – Thick Yellow Horizontal Bars
• Pengo board arriving today.
• Installed a switcher in the Pengo

If you enjoyed this post, please consider to leave a comment or subscribe to the feed and get future articles delivered to your feed reader.