Cap Kit for Wizard Of Wor

I finally got the capacitor kit for the Wells Gardner monitor today. Last week, when I had the whole week off I had intentions of going up to get the Wizard Of Wor Cap Kit, but wanted to combine a trip with something else, or take a bike ride. Well, needless to say, I never got around to it.

So, I got stuck with it this week, and it involved two long trips to Meunier (Indianapolis) to get it. One day to drop off the list, and then another day to go get it. It was significantly cheaper than getting it online though. I think without gas it cost about $6.75, and if you count my gas, maybe another $2. Not to mention, they didn’t have one of the caps, so I had to then run over to King’s Electronics down the street and get the last one. (Their prices suck, usually they are about 3x higher than Meunier)

Now it is Thursday, and I don’t know when I will get to do it. It is so hot outside and we have guests this weekend. Hopefully I will get to take the monitor out of the Wizard Of Wor at least and discharge it before the weekend is up.

Here are some similar arcade posts

• Replacement Capacitors for Wizard of Wor PCB
• Sorting out Wizard of Wor Caps
• 19K4635 Wells Gardner Monitor – Difficult to do a cap kit
• Video tutorials on discharging monitors and “doing” a cap kit
• Happs and Wolverine Electronics – Limited Selection

If you enjoyed this post, please consider to leave a comment or subscribe to the feed and get future articles delivered to your feed reader.