Cutting wood for Mr. Do! control panel
Tonight I went over to a friend’s to use some of his tools, and have him help me cut up a board to use on the back side of the control panel. It was some composite wood from a shelf, that we cut down to size, drilled the holes for the joystick and the two buttons, and then did some holes for the bolts to hold the clips on. He had a cool drill bit with a counter sink, but the hole size was just a fraction too small. Plus, the holes we drilled with his wood blades were just a touch too small. So, now I need to see if I can possibly purchase some wood blades to make the holes bigger, and look again for small but longer carriage bolts. But things are very close.
Here are some similar arcade posts
- Jr. Pac-man finished!
- Working on Dig Dug control panel, sanding carriage bolts
- Trimming down the new Ms. Pac-man back door.
- Reproducing Control Panel Artwork – Control Placement
- Sanding Pac-man cabinet, wiring Mr. Do!
If you enjoyed this post, please consider to leave a comment or subscribe to the feed and get future articles delivered to your feed reader.
Comments
No comments yet.
Leave a comment
Your email address is never displayed and cannot be spammed. If your comments are excessively self-promotional you will be banned from commenting. Read our comment privacy policy.