Double checking Professor Pac-man measurements

Took the Professor Pac control panel artwork tonight and did the measured adjustments on it. Of course I had to do some adjustments, my artwork seemed to be a little more short than the measurements when I scaled it down proportionately. I am guessing that next it should be printed out to scale, and laid over a current machine to make sure that it is pretty close to correct.

Hopefully Richard is able to print that off ok, even with margins, maybe at a local printer or something.

Here are some similar arcade posts

If you enjoyed this post, please consider to leave a comment or subscribe to the feed and get future articles delivered to your feed reader.

Comments

No comments yet.

Leave a comment

Your email address is never displayed and cannot be spammed. If your comments are excessively self-promotional you will be banned from commenting. Read our comment privacy policy.

(required)

(required)